Cisco Systems OL-15491-01 Manual do Utilizador descarregar pdf (Página 218)

A-218

Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide

OL-15491-01

Appendix A CSG2 Command Reference

records granularity

To specify the granularity at which CSG2 billing call detail records (CDRs) are to be generated, use the

records granularity command in CSG2 service configuration mode. To restore the default granularity,

use the no form of this command.

records granularity {transaction | service {bytes bytes | seconds seconds | bytes bytes

seconds seconds}}

no records granularity

Syntax Description

Defaults If you do not specify the records granularity command, CDRs are generated for each transaction.

If you specify records granularity service, you must also specify the bytes keyword, the seconds

keyword, or both:

• If you specify both the bytes keyword and the seconds keyword, a billing record is sent when either

limit is reached. Then both limits are reset.

• If you specify only the bytes keyword and not the seconds keyword, the maximum time between

billing records for a session is set to 0 seconds, indicating no time limit.

• If you specify only the seconds keyword and not the bytes keyword, the number of bytes of data

that triggers the sending of a billing record is set to 0 bytes, indicating no maximum.

Command Modes CSG2 service configuration

transaction Generate CDRs for each transaction. This is the default setting.

service Generate summarized, service-level CDRs.

bytes bytes Number of bytes of data, sent and received by a session, that triggers a CDR.

The difference between bytes sent and bytes received in two records might

not exactly equal the bytes argument, because updates must occur on packet

boundaries.

The range is from 5000 to 2147483647. The default value, if the bytes

keyword is not specified, is 0, indicating no maximum.

seconds seconds Maximum time, in seconds, between billing records for a session. Records

can be sent more frequently if the number of bytes is reached.

When a record is sent because the maximum time has been reached, the byte

counts reported in the record are approximate.

The range is from 5 to 86400. The default value, if the time keyword is not

specified, is 0, indicating no time limit.

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 255 256

Sem comentários

Cisco Systems OL-15491-01 Manual do Utilizador Página 218