Cisco Systems WSC2960XR48FPSI Manual do Utilizador descarregar pdf (Página 148)

PurposeCommand or Action

Example:

Switch(config-if)# switchport mode

Use the no switchport mode dot1q-tunnel interface

configuration command to return the port to the default

state of dynamic desirable.

Note

dot1q-tunnel

Returns to privileged EXEC mode.exit

Step 5

Example:

Switch(config-if)# exit

(Optional) Sets the switch to enable tagging of native VLAN packets

on all IEEE 802.1Q trunk ports. When not set, and a customer

vlan dot1q tag native

Example:

Switch(config)# vlan dot1q tag native

Step 6

VLAN ID is the same as the native VLAN, the trunk port does not

apply a metro tag, and packets could be sent to the wrong

destination.

Use the no vlan dot1q tag native global configuration

command to disable tagging of native VLAN packets.

Note

Returns to privileged EXEC mode.end

Example:

Switch(config)# end

Step 7

Displays the ports configured for IEEE 802.1Q tunneling.Use one of the following:

Step 8

Displays the ports that are in tunnel mode.

•

show dot1q-tunnel

•

show running-config interface

Example:

Switch# show dot1q-tunnel

Switch# show running-config interface

Displays IEEE 802.1Q native VLAN tagging status.show vlan dot1q tag native

Step 9

Example:

Switch# show vlan dot1q native

Catalyst 2960-XR Switch VLAN Configuration Guide, Cisco IOS Release 15.0(2)EX1

134 OL-29440-01

Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling

Configuring an IEEE 802.1Q Tunneling Port

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 177 178

Comentários a estes Manuais

Sem comentários

Cisco Systems WSC2960XR48FPSI Manual do Utilizador Página 148

Comentários a estes Manuais

Manuais e produtos relacionados com Comutadores de rede Cisco Systems WSC2960XR48FPSI