Cisco Systems 4xGBE Guia do Utilizador descarregar pdf (Página 58)

Chapter 4 Installation and Maintenance

Removing and Replacing a Power Supply Unit

SCE 2000 4xGBE Installation and Configuration Guide

4-22 OL-7824-02

Note

The power supply is not fully seated until you tighten the installation screw on the faceplate.

This completes the procedures for replacing a power supply in a SCE 2000 platform.

Reconnecting the Power

The following sections describe how to reconnect the AC or DC power:

• Reconnecting AC-Input Power Supply Unit (on page 4-22)

• Reconnecting DC-Input Power Supply Unit (on page 4-23)

Reconnecting AC-Input Power Supply Unit

The following procedures explain how to reconnect an AC-input power to the SCE 2000

platform.

If you are reconnecting DC-input power, proceed to Reconnecting DC-Input Power Supply Unit

(on page 4-23).

To reconnect the AC-input power to the SCE 2000 platform, complete the following steps:

Step 1 Plug the AC-input power cable into the AC-input power receptacle on the AC-input

power supply

Figure 4-14: Connecting the AC Power

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 151 152

Sem comentários

Cisco Systems 4xGBE Guia do Utilizador Página 58