Cisco Systems Network Device 2800 Manual de Instalação descarregar pdf (Página 159)

Installing and Upgrading Internal Modules in Cisco 2800 Series Routers

OL-5792-04

Replacing the Power Supply

Figure 30 Installing a PVDM

Step 4

If you are finished installing modules, install the cover on the router. See the “Installing the Chassis

Cover” section on page 51.

Replacing the Power Supply

To install an inline power (ILP) supply in a Cisco 2801 router, remove the chassis cover as described in

the “Removing the Chassis Cover” section on page 2, and perform the procedure in the “Installing an

Inline Power Supply in a Cisco 2801 Router” section on page 31.

To replace a power supply in a Cisco 2811 router, remove the chassis cover as described in the

“Removing the Chassis Cover” section on page 2, and perform the procedure in the “Installing a Power

Supply in a Cisco 2811 Router” section on page 33.

To replace a power supply in a Cisco 2821 or Cisco 2851 router, remove the chassis cover as described

in the “Removing the Chassis Cover” section on page 2, and perform the procedure in the “Installing a

Power Supply in a Cisco 2821 or Cisco 2851 Router” section on page 41.

Caution To comply with Telcordia NEBS GR-1089-Core and EN 300386 requirements, you must use foil

twisted-pair cable that is properly grounded at both ends.

Installing an Inline Power Supply in a Cisco 2801 Router

To replace the main power supply in a Cisco 2801 router with an inline power supply, perform the

following steps. See Figure 8 for the locations of connectors and other components within the

Cisco 2801 router.

Step 1 Disconnect the power supply cable from the main power supply connector.

Step 2 Remove the screws that fasten the main power supply to the chassis. See Figure 31.

1 Tilt PVDM up to vertical 2 Clips snap into place

103469

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 185 186

Sem comentários

Cisco Systems Network Device 2800 Manual de Instalação Página 159