Cisco Systems SFS 3012R Manual de Instalação descarregar pdf (Página 53)

3-9

Cisco SFS 3012R Multifabric Server Switch Hardware Installation Guide

OL-11187-01

Chapter 3 Installing and Removing Server Switch Field Replaceable Units (FRUs)

Removing a Power Supply Module

Caution Never place your hand inside an empty module bay or anywhere inside the Cisco SFS 3012R Server

Switch.

To remove the power supply, perform the following steps:

Step 1 Ground yourself using an approved ground wrist strap.

Step 2 Remove the power cord from the power supply.

Step 3 Disengage the power supply by pulling it toward you.

Step 4 Slide the power supply out of the chassis.

Step 5 Either replace the power supply immediately or fasten a blanking panel to the empty chassis bay to

ensure appropriate cooling.

Note The blanking panel is a flat sheet of metal with the same dimensions as the power module

faceplate.

Caution Never operate the device without a blanking panel or power supply module in place because

the device might overheat.

Installing a Blower Module

To insert a blower module, perform the following steps:

Step 1 Ground yourself using an approved ground wrist strap.

Step 2 Remove the blower module from any packaging.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 83 84

Sem comentários

Cisco Systems SFS 3012R Manual de Instalação Página 53