Cisco Systems MGX 8850 System Guia do Utilizador descarregar pdf

Corporate Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706. USA

78-10389-01

Installing Plastic Motherboard Insulator in an

MGX 8850 System

Installing Backplane Plastic Insulating Cover

Use the following procedure to install the insulating cover over a system’s backplane. This procedure

may be done without powering down the system.

Step 1 Open the plastic grill on the front side of the intake plenum, located directly underneath the card cage

or the fan space, using a flat blade screw driver to loosen the two recessed screws. Tilt the plastic grill

forward about 45 degrees, then lift out and set it aside.

Step 2 Hold the plastic cover, shown in the drawing below, so that the 16 short tabs are facing towards you.

43776

3 Tabs

Short tabs

1 2 3 4

2Installing Plastic Motherboard Insulator in an MGX 8850 System 78-10389-01Step 3 The next illustration shows the clear plastic backplane cover viewe

3Installing Plastic Motherboard Insulator in an MGX 8850 System 78-10389-01Step 5 Align the two cutouts on the plastic cover with the two sheetmetal

4Installing Plastic Motherboard Insulator in an MGX 8850 System 78-10389-01Step 6 Press the center of the plastic cover to snap the tabs into the car

Sem comentários

Cisco Systems MGX 8850 System Guia do Utilizador