Cisco Systems Network Cabling Manual do Utilizador descarregar pdf (Página 10)

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE 25

2. Enter the privileged mode, as follows:

3. Enter the configuration mode, as follows:

Enter configuration commands, one per line. End with CNTL/Z.

4. Turn the messages off, as follows:

5. Turn off all interfaces on the first switch, as follows:

6. Turn off all the interfaces on the second switch, as follows:

At this prompt... Enter... Notes

Switch> enable

At this prompt... Enter... Notes

Switch# configure terminal

Displays the following output:

At this prompt... Enter... Notes

Switch(config)# no logging console

Some of the switch configuration

commands can produce many

messages that are logged to the

console, which is often

inconvenient.

At this prompt... Enter... Notes

Switch(config)# interface range GigabitEthernet 1/0/1 – 24

This step is done to prevent

network loops from forming

because the configuration is only

partially enabled at this time.

Switch(config-if-

range)#

shutdown

Switch(config-if-

range)#

exit

At this prompt... Enter... Notes

Switch(config)# interface range GigabitEthernet 2/0/1 – 24

This is done for the same reason as

stated in the previous step.

Switch(config-if-

range)#

shutdown

Switch(config-if-

range)#

exit

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Sem comentários

Cisco Systems Network Cabling Manual do Utilizador Página 10