Cisco Systems IEM30004PC Manual de Instalação descarregar pdf (Página 66)

2-40

Cisco IE 3000 Switch Hardware Installation Guide

OL-13017-01

Chapter 2 Switch Installation

Connecting Destination Ports

Step 6 Insert the LC cable connector into the SFP module.

Removing SFP Modules from SFP Module Slots

To remove an SFP module from a module receptacle, follow these steps:

Step 1 Attach an ESD-preventive wrist strap to your wrist and to a grounded bare metal surface.

Step 2 Disconnect the LC from the SFP module.

Step 3 Insert a dust plug into the optical ports of the SFP module to keep the optical interfaces clean.

Step 4 Unlock and remove the SFP module. See Figure 2-34.

If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp

latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver

or other long, narrow instrument to open the bale-clasp latch.

Figure 2-34 Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver

Step 5 Grasp the SFP module between your thumb and index finger, and carefully remove it from the module

slot.

Step 6 Place the removed SFP module in an antistatic bag or other protective environment.

1 Bale clasp

201867

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 169 170

Sem comentários

Cisco Systems IEM30004PC Manual de Instalação Página 66