Cisco Systems RF Gateway 10 Guia de Início Rápido descarregar pdf (Página 24)

Figure 17 Aligning the UCH with the RF switch card Dense Connector Ports

Figure 18 Installing the UCH on the Faceplate

Step 5 Repeat steps 1 through 4 for the remaining 11 UCH to RF switch card interconnects.

Note The RF switch cards connect orthogonally across all Universal RF line cards in the system picking up one connector off

each card. It is required to install all the 12 UCH to all the 12 RF switch cards so that the coaxial cables can be

connected even if only one RF line card is installed in the system.

Installing or Replacing the Cables in the UCH2

This section describes how to install and replace the UCH2 cables. The UCH2 universal cable holders must be used with the

Cisco RFGW-10 RF switch line cards. The UCH is designed to stabilize the cables and hold them in place.

273863

Cutout

Red line

Lead screw

Shroud

273864

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Sem comentários

Cisco Systems RF Gateway 10 Guia de Início Rápido Página 24