Cisco Systems RF Gateway 10 Guia de Início Rápido descarregar pdf (Página 7)

Figure 2 Verifying Equipment Rack Dimensions

Installing the Chassis Installation Brackets

Each chassis is shipped with two chassis installation brackets in the accessory kit. These brackets are to aid in installing a chassis

into a 19 inch rack and used as a support base to vertically position and set the chassis before the rack-mount screws are

installed.

To install the chassis installation brackets into a rack, complete the following steps:

Step 1 Determine where in the rack you want the chassis to be mounted. If you are mounting more than one chassis in the

rack, then start from the bottom up or the center of the rack. Install the chassis installation bracket where the chassis

bottom will be positioned vertically in the rack.

Step 2 Secure the chassis installation bracket to the front rails with the rack-mount screws.

Step 3 If there is a second internal rack rail, which is not more than 20 inches from the front rail, you can position the second

installation bracket to act as a rear support for the chassis during installation.

Figure 3 shows the brackets attached in a rack.

Minimum usable

aperture 17.7 inches

(45.0 cm)

Hole centerline

to hole centerline

18.31 inches ± 0.06 inches

(46.5 cm ± 0.15 cm)

Mounting flanges

28014

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Sem comentários

Cisco Systems RF Gateway 10 Guia de Início Rápido Página 7