Cisco Systems RF Gateway 10 Guia de Início Rápido descarregar pdf (Página 25)

Tools and Equipment

The tools listed below are designed to help you remove and install the cables in the UCH2.

• T-10 TORX driver tool—Removes the cable clamp bar

Note Do not use heat-shrink wrap on quad-shielded cables.

• Cables—75-ohm quad-shielded precision miniature video cable, bonded foil 1855 type (reference YR50386 and YR52310,

Belden five pack bundles)

Installing Cables

Cisco cables are color-coded for easy reference and installation. The cable color corresponds to a specific port on the card.

See Table 5 for a list of the cable ports and its associated cable color for a five bundle quad-shielded cabling. The table includes

a column for you to define ports and color definitions.

Note Other color options for precision miniature video coaxial cables may be available, contact Belden for more information.

You can use any cable color combination but Table 5 is the reference color configuration.

Ta b l e 5 RF Switch Universal Cable Holder Reference Color Coding

To replace cables or install new cables in an UCH2, complete the following steps:

Step 1 Use the T-10 TORX driver tool to loosen the lock bar on the side where the cable is installed.

Step 2 Use a flathead screw driver as a lever to slide open the lock bar (if needed).

Step 3 Remove the ESD cap from a cable (see Figure 19 and Figure 20) and place it in the hole in the UCH2. (See Figure 21.)

Use Table 5 to determine the correct color and location for each colored cable.

RF Switch Line Card Port Cable Color RF Switch User Defined

RFSW Slot 12 Red

RFSW Slot 11 White

RFSW Slot 10 Blue

RFSW Slot 9 Green

RFSW Slot 8 Yellow

RFSW Slot 7 Violet

RFSW Slot 6 Orange

RFSW Slot 5 Black

RFSW Slot 4 Gray

RFSW Slot 3 Brown

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Sem comentários

Cisco Systems RF Gateway 10 Guia de Início Rápido Página 25