Cisco Systems XR 12410 Manual de Instalação descarregar pdf (Página 104)

Chapter 3 Installing the Cisco XR 12410 Router

Reinstalling Components After Installing the Chassis

3-28

Cisco XR 12410 Router Installation Guide

OL-13832-01

Reinstalling AC PEMs

Use the following procedure to reinstall the AC PEMs back into the chassis.

Step 1 Install the AC PEMs (Figure 3-20):

a. Slide the power supply into the bay until it mates with its backplane

connector.

b. Lift the ejector lever into place and tighten the captive screw to securely seat

the power supply to the backplane connector.

Caution To prevent damage to the power shelf backplane connector, do not use excessive

force when inserting the power supply into the chassis.

Figure 3-20 Installing an AC PEM

Step 2 Repeat Step 1 for the other power supply.

Step 3 Go to the “Reinstalling the Blower Module” section on page 3-30 to install the

blower module.

93228

PWR OK

FAULT

TEMP

ILIM

WR OK

FAULT

TEMP

ILIM

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 229 230

Sem comentários

Cisco Systems XR 12410 Manual de Instalação Página 104