Cisco Systems XR 12410 Manual de Instalação descarregar pdf (Página 116)

Chapter 3 Installing the Cisco XR 12410 Router

Connecting PRP Route Processor Cables

3-40

Cisco XR 12410 Router Installation Guide

OL-13832-01

Note RP cables are not available from Cisco, but are available from any commercial

cable vendor.

Note To comply with the intra-building lightning surge requirements of

GR-1089-CORE, Issue

II, Revision 01, February 1999, you must use a shielded

cable when connecting to the console, auxiliary, and Ethernet ports. The shielded

cable is terminated by shielded connectors on both ends, with the cable shield

material tied to both connectors.

Connecting to the PRP Console Port

The system console port on the PRP is a DCE RJ-45 receptacle for connecting a

data terminal to perform the initial configuration of the router. The console port

requires a straight-through RJ-45 cable.

See the “PRP Auxiliary and Console Port Connections” section on page 2-22 for

additional information about the console port.

Refer to Figure 3-28 and use the following procedure to connect a data terminal

to the PRP console port.

Step 1 Set your terminal to these operational values: 9600 bps, 8 data bits, no parity,

stop bits (9600 8N2).

Step 2 Power off the data terminal.

Step 3 Attach the terminal end of the cable to the interface port on the data terminal.

Step 4 Attach the other end of the cable to the PRP console port.

Step 5 Power on the data terminal.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 229 230

Sem comentários

Cisco Systems XR 12410 Manual de Instalação Página 116