Cisco Systems MGX 8850 Guia do Utilizador descarregar pdf (Página 335)

100

101

5-41

Cisco MGX 8850 Routing Switch Command Reference

Release 2.0, Part Number 78-10467-04 Rev C0, October 2001

Chapter 5 PNNI Commands

cnfpnni-svcc-rcc-timer

Configure PNNI Switched Virtual Connection Routing Control Channel (SVCC-RCC) Timer—specify the parameters

for any PNNI RCCs between logical nodes.

The current release does not support this command. The cnfpnni-svcc-rcc-timer command lets you

specify the initial PNNI SVCC-based variables for a network node. Logical group nodes (LGNs) use

SVCC-RCCs to exchange routing information.

Cards on Which This Command Runs

PXM45

Syntax

cnfpnni-svcc-rcc-timer <node-index>

[-initTime init-time]

[-retryTime retry-time]

[-callingIntegrityTime calling-integrity-time]

[-calledIntegrityTime called-integrity-time]

Syntax Description

node-index In the current release, the only supported value for node-index 1. The node

index indicates the relative level of the logical node within a multi-peer

group on the switch. The range is 1–10, and the lowest level is 1.

Range: 1–10

Default = 1

-initTime The number of seconds this node waits before it advertises its choice of

preferred SVCC to a neighbor with a numerically lower ATM address. This

node does so after determining that such an SVCC should be established.

Range: 1–10 seconds

Default = 10

-retryTime The number of seconds this node waits before it attempts to re-establish an

apparently necessary and viable SVCC-based RCC that was unexpectedly

torn down.

Range: 10–60 seconds

Default = 60

1 2 ... 330 331 332 333 334 335 336 337 338 339 340 ... 785 786

Comentários a estes Manuais

Sem comentários

Cisco Systems MGX 8850 Guia do Utilizador Página 335

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Cisco Systems MGX 8850