Cisco Systems MGX 8850 Guia do Utilizador descarregar pdf (Página 466)

100

101

6-48

Cisco MGX 8850 Routing Switch Command Reference

Release 2.0, Part Number 78-10467-04 Rev C0, October 2001

Chapter 6 Logical Node, Port, and Signaling Commands

cnfsigdiag

Configure Signaling Diagnostic

The cnfsigdiag command lets you create a filter table for signaling diagnostics or disable signaling

diagnostics. Signaling diagnostics are disabled by default.

The ATM signaling diagnostics are tools for troubleshooting call failures in the network and should not

be enabled while the switch is operating.

Cards on Which This Command Runs

PXM45

Syntax

cnfsigdiag {[enable | disable | index]}

[-cldaddr nsap-address]

[-clgaddr nsap-address]

[-cldaddrmask atm-address-mask]

[-clgaddrmask atm-address-mask]

[-casttype {all | p2p | p2mp}]

[-clrcause clear-cause-code]

[-connctgy {all | svc | svp | swvc | swvp}]

[-inport portid]

[-outport portid]

[-maxrec max-num-records ]

[-scope {all | ext | int}]

[-servctgy {all | cbr | rtvbr | nrtvbr | ubr | abr}]

[-status {active | inactive}]

Syntax Description

enable,

disable, or

index

Enable or disable signaling diagnostics or configure an index.

Specify the diagnostics index number for the filter table and enter the diagnostics

configuration mode. The range for index is 1–50. If you do not specify an index, the

enable or disable condition globally applies to all signaling diagnostics.

Default: disable

-cldaddr The nsap-address is the filter for ATM signaling call failures against this called

address.

Default: NULL

-clgaddr The nsap-address is the filter for ATM signaling call failures against this calling

address.

Default: NULL

1 2 ... 461 462 463 464 465 466 467 468 469 470 471 ... 785 786

Comentários a estes Manuais

Sem comentários

Cisco Systems MGX 8850 Guia do Utilizador Página 466

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Cisco Systems MGX 8850